Clean the filters

Regularly clean the filters

There are two filters fitted to the cleaner and keeping them clean will ensure that it has great suction and picks up efficiently. The first one is fitted under the dust container, simply unclip the container and the filter cover to get to the pre motor filter. The second one can be found by turning the cleaner over and unclipping the exhaust filter from its housing as shown.


Dust the filters clean with a soft brush or for best results wash them in warm water but please allow them to dry thoroughly before putting them back. This may take up to 24 hours. Hoover recommend that new filters are fitted if no improvement is noticed after cleaning them and at least one per year. new ones can be obtained from the spares section of this web site.

Filter care
Buy spare parts online
Phone 03446 923 608 to book your repair

Always disconnect your appliance from the mains before you start examining it!

Did you find this useful?

This solution applies to the following models:

Regularly clean the filters

Regular cleaning of the exhaust filter on the top of the main body and the dust container filter will keep the product working efficiently. Wash the two filters in warm water ensuring they are thoroughly dry before re fitting them.

Hoover recommend that you replace the filters at least once per year and new ones can be purchased from the spares section of the website.

Dust container filterRemoving the exhaust filter
Buy spare parts online
Phone 03446 923 608 to book your repair

Always disconnect your appliance from the mains before you start examining it!

Did you find this useful?

This solution applies to the following models:

Vacuum Cleaners

Check the condenser filter

The condenser filter is located behind the bottom cover or plinth and should be inspected and cleaned regularly. This will keep your dryer working efficiently and cut down the time taken to dry the clothes.

Start by removing the lower cover by grasping the ends and pulling it away from the machine as shown. The filter can be seen on the left hand side unlock it by twisting the red toggles.

remove the plinthunlock the filter

Pull the filter out from the body of the dryer ready for cleaning. Peel the black foam pad away from the filter frame and wash this in warm water. Using a soft brush dust away any fluff attached to the mesh screen and body of the filter. re fit the filter and plinth and the dryer is ready for use.

remove the filterwith the filter out the foam pad can be removed for cleaning

foam pad being peeled away from the filter body ready for cleaning

Buy spare parts online
Phone 03446 923 608 to book your repair

Always disconnect your appliance from the mains before you start examining it!

Did you find this useful?

This solution applies to the following models:

Our website uses cookies. Cookies enable us to provide the best experience possible and help us understand how customers use our website. Our site won't work without them. By continuing to use our website you accept our use of cookies. Find out more about cookies.

×

Locating Appliance Information Plates

Hoover typical model number plate
Appliance information plates can be found on the front, back, side, rim or base of Hoover appliances.
Washing Machine
Washer Dryer
Dishwasher
Microwave
Single Oven
Double Oven
Hob
Hood
Vacuums