Aftersales Service

03444 995599

Can’t see your model? Visit our Advice Centre

Clean the door filter before every use

The fluff filter is found in the bottom of the door recess, lift it out and clean any fluff and lint from the mesh trap. Hoover recommend you do this before you start each drying cycle.

Average rating:

Read more

The fluff filter is found in the bottom of the door recess, lift it out and clean any fluff and lint from the mesh trap. Hoover recommend you do this before you start each drying cycle.

Phone 03446 923 608 and we’ll assess the best resolution for your problem.

Always disconnect your appliance from the mains before you start examining it!

Average rating:

Did you find this useful?

Something went wrong. Please try again.

Thank you!

This solution applies to the following models:

Tumble Dryers

Regularly clean the filters

There are two filters fitted to the cleaner and keeping them clean will ensure that it has great suction and picks up efficiently. The first one is fitted under the dust container, simply unclip the container and the filter cover to get to the pre motor filter. The second one can be found by turning the cleaner over and unclipping the exhaust filter from its housing as shown.

Read more

There are two filters fitted to the cleaner and keeping them clean will ensure that it has great suction and picks up efficiently. The first one is fitted under the dust container, simply unclip the container and the filter cover to get to the pre motor filter. The second one can be found by turning the cleaner over and unclipping the exhaust filter from its housing as shown.


Dust the filters clean with a soft brush or for best results wash them in warm water but please allow them to dry thoroughly before putting them back. This may take up to 24 hours. Hoover recommend that new filters are fitted if no improvement is noticed after cleaning them and at least one per year. new ones can be obtained from the spares section of this web site.

Filter care

Phone 03446 923 608 and we’ll assess the best resolution for your problem.

Always disconnect your appliance from the mains before you start examining it!

Did you find this useful?

Something went wrong. Please try again.

Thank you!

This solution applies to the following models:

Vacuum Cleaners

Regularly clean the filters (1)

Regular cleaning of the exhaust filter on the top of the main body and the dust container filter will keep the product working efficiently. Wash the two filters in warm water ensuring they are thoroughly dry before re fitting them.

Read more

Regular cleaning of the exhaust filter on the top of the main body and the dust container filter will keep the product working efficiently. Wash the two filters in warm water ensuring they are thoroughly dry before re fitting them.

Hoover recommend that you replace the filters at least once per year and new ones can be purchased from the spares section of the website.

Dust container filter Removing the exhaust filter

Phone 03446 923 608 and we’ll assess the best resolution for your problem.

Always disconnect your appliance from the mains before you start examining it!

Did you find this useful?

Something went wrong. Please try again.

Thank you!

This solution applies to the following models:

Vacuum Cleaners

Check the condenser filter

The condenser filter is located behind the bottom cover or plinth and should be inspected and cleaned regularly. This will keep your dryer working efficiently and cut down the time taken to dry the clothes.

Average rating:

Read more

The condenser filter is located behind the bottom cover or plinth and should be inspected and cleaned regularly. This will keep your dryer working efficiently and cut down the time taken to dry the clothes.

Start by removing the lower cover by grasping the ends and pulling it away from the machine as shown. The filter can be seen on the left hand side unlock it by twisting the red toggles.

remove the plinth unlock the filter

Pull the filter out from the body of the dryer ready for cleaning. Peel the black foam pad away from the filter frame and wash this in warm water. Using a soft brush dust away any fluff attached to the mesh screen and body of the filter. re fit the filter and plinth and the dryer is ready for use.

remove the filter with the filter out the foam pad can be removed for cleaning

foam pad being peeled away from the filter body ready for cleaning

Phone 03446 923 608 and we’ll assess the best resolution for your problem.

Always disconnect your appliance from the mains before you start examining it!

Average rating:

Did you find this useful?

Something went wrong. Please try again.

Thank you!

This solution applies to the following models:

Tumble Dryers