Demo Mode. Are the keys on your dishwasher not functioning correctly. Your machine maybe in demo mode

To Clear

Switch on the machine

Press and Hold the Program and Start Delay button, wait  for 3 seconds

The buttons should now function correctly

Should a 'H' with a number be shown the display, for example 'H02' then the delay start has been activated. The number indicates in how many hours in the future, the machine will start. So in our example the machine will switch on by itself in 2 hours time. You will not be able to use the machine instantly unless you cancel the delay start. The machine can be programmed to come on up to 24 hours in advance. To re set simply press the delay start button found on the option button cluster repeatedly  until 'H0' appears. The machine will now commence the cycle when you press the start button.

If the buttons on the machine are unresponsive or the cycle will not start demo mode may have been activated. To remove from demo mode press and hold the buttons "Memo" and "Anti crease" for 7 seconds. 

If the buttons on the machine are unresponsive or the cycle will not start demo mode may have been activated. To remove from demo mode press and hold the buttons shown

For Hwash Models

Spin and Stain/rapid for 7 seconds

For AXI 

"Total Care" and "options"

For other models

"Delay Start" and "Spin" for 7 seconds

Check that the water tank found in the door is not full. Once it becomes full the dryer will stop working until the water is emptied away. Open the door and lift the tank off, taking acre as it may be heavy. Pour the water down your sink or drain.

Check that you have closed the door properly. Open the door and check that nothing has became trapped in the door opening. Shut the door firmly and try again.

There is a slight delay before the machine starts the cycle, during which time the safety lock activates.

Your tumble dryer has been designed to be used in a habitable part of your home. During the winter, cold temperatures are detected by sensors inside the appliance which causes it to shut down. This may occur in colder parts of your home such as a garage or out building during a 'cold snap' when we experience temperatures bellow zero. In these conditions the machine will turn on but not start up and the lights may flash. Simply warm up the surroundings or alternatively open the door, remove the filter and using a hair dryer blow warm air into the machine through the filter slot. Do this for a few minutes and then try the dryer again... it should now start to work. This is not a fault with your dryer it is simply due to the location of your machine during extremely cold weather. We recommend you re-locate the product to a warmer environment.

using a hair dryer to warm up the surrounding temperature

If the water is not turned on the machine will not start the programme as it needs a supply of water at the start. Check that your water tap behind the machine or in a cupboard next to the machine is turned on. If it has just been installed or recently moved check that the water fill pipe has not been crushed or kinked.

This picture shows the water turned off

here we see the blue valve in line with the pipe and the water supply is turned on if the supply is from a tap twist the tap anti clockwise to turn it on

Dependent on model:

Some AXI models will not start to fill up with water should the soap drawer be open. Check the drawer has been pushed fully back into the machine.

Check that you have power to the machine. Try another product in the socket and see if it works, If it does not then it may be the electrical socket in your home at fault. Replace the fuse, take a fuse from something else that is working: the kettle or toaster perhaps? pop the fuse in the plug and try again.

the fuse is found in the middle of the plug as shown